Owner`s manual

4.6 Input/output connectors
Every channel has the following connectors at the back of the housing.
The balanced
LINE input is a stereo 1/4" jack socket:
Tip = hot
Ring = cold
Sleeve = shield
The
INSERT is on a stereo jack socket.
Tip = return
Ring = send
Sleeve = shield
The ground compensated
DIRECT output is a stereo 1/4" jack socket:
Tip = hot
Ring = cold
Sleeve = shield
Note:
The default setting on this output is -1 0dB V, a setting of -+ 4dBu can be chosen on the channel (PCB) boards
using jumpers.
The
REMOTE connector is internally wired to a 4 pin connector that can be wired to a faderstart switch if ordered:
Tip = normally open
Ring = normally closed
Sleeve = centre contact
A balanced XLR connector is for the
MIC rophone input.
Pin 1 = shield
Pin 2 = hot (in phase)
Pin 3 = cold (out of phase)
4.7 Jumper/connector information
J 17=Remote connector pin1=tip
pin2=ring
pin3=sleeve
J1 0=Tape return connector pin1 =tip/break on line input
pin2=ring/ break on line input
J1= Mic input connector pin1= ground
pin2=hot (in phase)
pin3=cold (outpof phase)
J7=Aux3/4 pre/post select pin1/2=post
pin3/4=pre
J8=Aux5/6 pre/post select pin1/2=post
pin3/4=pre
J9=Aux7/8 pre/post select pin1/2=post
pin3/4=pre
J9=Aux4 pre/post select pin1/2=post
pin3/4=pre
J5=fader when automation is installed 1=ground
2=wiper
3 Top of fader