User`s manual

9
TROUBLESHOOTING Q & A CONT.
4. Q : My Transmitter LED lights when any button on
the transmitter is pushed, and the collar LED is
blinking (indicating the unit is ON), but the unit
is not working.
A: The transmitter and collar frequencies are not in
synch. Try the following procedure to restore...
1.
Turn the collar ON by depressing and holding
the Power and Mode Selector Switch for
approximately two seconds.
DO NOT STOP
PRESSING THE SWITCH.
2. Keep the switch held down until you hear 3
quick beeps from the collar. (This takes about
10 seconds).
3. Now push one of the buttons on the
Transmitter (it does not matter which button
you push).
4. You should now hear a series of 5 quick
beeps.
5. Turn the unit OFF, (by depressing and
holding the Power and Mode Selector Switch
for approximately two seconds) and then turn
it back ON.
6. If the unit is still not working repeat steps 1-5.