INSTRUCTION BOOK FOR Tensioned Large Advantage® Deluxe Electrol®
Important Safety Instructions Pre-Installation When using your video equipment, basic safety precautions should always be followed, including the following: 1. 1. 2. Make sure to recheck measurements of screen location before installation. Read and understand all instructions before using. 2. Close supervision is necessary when any appliance is used by or near children. Do not leave appliance unattended while in use. Carefully unpack screen and remove outer wrapping from case.
Screen And Roller Assembly Installation If your screen was shipped with the motor and roller already installed proceed to step 7. 1. Remove four bolts from ends of door assembly (2 bolts on each end) (Fig. 1). This will allow the door assembly to drop open for access to case. For larger sizes, you will also need to remove the door support screws. 2. Carefully unpack screen and roller assembly. Leave packing paper on the roller. CAUTION! Do not cut tape on fabric with a knife or any sharp tool.
Tensioned Large Advantage Deluxe® Electrol® Instructions Front of Wall Switch 120V Wiring Diagram Back of Wall Switch NOTE: 20-24AWG WIRE RECOMMENDED FOR CONNECTING WALL SWITCH TO DUAL MOTOR CONTROLLER.
Tensioned Large Advantage Deluxe® Electrol® Installation 9 1/8" (Suggested) ½" Threaded Rod (Not Included) Attached To Mounting Bracket Screen Roller Audience Side 12 3/16" 11" 11 7/16" Door Roller Finished Ceiling Self-Trimming Flange Self-Trimming Flange 13 1/8" Access Door Closing Door 10 13/16" 2 5/16" 11" Variable Position Mounting Brackets Case Length 10" 11 ½" Electrical Junction Box 10" 5
Troubleshooting Visit www.da-lite.com/products/tutorials.php to find installation and troubleshooting tutorials. You will also find a link to Live Chat for interactive support and you can contact us by email at info@da-lite.com or by phone at (800) 622-3737 or (574) 267-8101 with any troubleshooting questions. Symptom Cause Solution Screen will not operate or will not go “down”. Motor does not hum. Incorrect line voltage. Verify 115-125V (or 220-240V).
Troubleshooting (continued) Symptom Cause Solution Spring has an obstruction not allowing door to open.. Check installation to free door. Clear any foreign substance from spring. No power. See above. Mis-adjusted door motor limit. Adjust door motor limit. Call Da-Lite for instruction. Low voltage board has no power or a blown transformer. Replace low voltage board. “Down” limit switch incorrect.. “Down” limit switch out of adjustment. See installation instructions. Noise.
LIMITED ONE YEAR WARRANTY ON DA-LITE PRESENTATION PRODUCTS Milestone AV Technologies LLC warrants certain Da-Lite branded products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; provided they are properly operated according to Da-Lite’s instructions and are not damaged due to improper handling or treatment after shipment from the factory.