Instruction Book for Large AdvantaGE® ElectroL®
IMPORTANT SAFETY INSTRUCTIONS When using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3. If an extension cord is necessary, a cord with a current rating at least equal to that of the appliance should be used. Cords rated for less amperage than the appliance may overheat. 4.
SCREEN AND ROLLER ASSEMBLY INSTALLATION Tools required for screen and roller assembly: 9/16“ Open Wrench or Socket Driver 1/2“ Open Wrench or Socket Driver 5/32“ Hex Key If your screen was shipped with the motor and roller already installed proceed to step 7. 1. Remove the access door. First, remove the 2 bolts from each end with a 9/16" open wrench or socket driver. Next, use a 5/32" hex key to remove the two screws in the center of the access door.
Large ADVANTAGE® ELECTROL® INSTALLATION 9-1/8" (Suggested) 1/2" Threaded Rod (Not Included) Attached to Mounting Bracket Electrical Junction Box 12-3/16" Screen Roller 11" Audience Side 11-7/16" Finished Ceiling Self-Trimming Flange 13-1/8" Variable Position Mounting Brackets Electrical Junction Box 4 Self-Trimming Flange Access Door 2-3/16" 10-15/16"
SCREEN ADJUSTMENT Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly adjusted at Da-Lite. Should it be necessary to adjust for more or less drop of picture, proceed in the following manner: NOTE: Use a screw driver or 5/32" Allen wrench to make adjustments. More Screen Drop LVC Control Box 1. Place operating switch in “down” position. 2. When the screen stops, turn the white “down” limit knob one-quarter turn counterclockwise (Figure 4).
120V WIRING DIAGRAM WITH OPTIONAL BUILT-IN LOW VOLTAGE CONTROL Note: 20-24 AWG wire recommended for connecting wall switch to low voltage controller. CAUTION: Do not use 3-position high voltage rocker switch with this unit! This will damage the low voltage control board.
240V WIRING DIAGRAM WITH OPTIONAL BUILT-IN LOW VOLTAGE CONTROL Note: 20-24 AWG wire recommended for connecting wall switch to low voltage controller. CAUTION: Do not use 3-position high voltage rocker switch with this unit! This will damage the low voltage control board.
TROUBLESHOOTING Visit www.da-lite.com/products/tutorials.php to find installation and troubleshooting tutorials. You will also find a link to Live Chat for interactive support. Symptom You can contact us by email at info@da-lite.com or by phone at 800.622.3737 or 574.267.8101 with any additional troubleshooting questions. Cause Solution Incorrect line voltage. Verify 115-125V (or 220-240V). If insufficient voltage, rewire incoming electric line. Blown fuse. Replace fuse. Tripped circuit breaker.
LIMITED FIVE YEAR WARRANTY ON DA-LITE Large ADVANTAGE® ELECTROL® PRODUCTS ONLY Da-Lite Screen Company LLC warrants these products to the original purchaser only, to be free from defects in materials and workmanship for a period of five (5) years from the date of purchase by the original purchaser provided they are properly operated according to Da-Lite’s instructions and are not damaged due to improper handling or treatment after shipment from the factory.
