INSTALLATION AND OPERATING INSTRUCTIONS FOR Single Motor Low Voltage Control System
Important Safety Instructions When using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3. If an extension cord is necessary, a cord with a current rating at least equal to that of the appliance should be used. Cords rated for less amperage than the appliance may overheat. 4.
AC Power Connections Screen Motor 1. Connect the motor wires in the screen junction box to the LVC wires labeled “motor wires”. Refer to diagram 2. 2. Use 14-18 gauge wire to extend the motor wire to the required length.
Troubleshooting Visit www.da-lite.com to find installation and troubleshooting tutorials. You will also find a link to Live Chat for interactive support and you can contact us by email at info@da-lite.com or by phone at (800) 622-3737 or (574) 267-8101 with any troubleshooting questions. Symptom Cause Solution No power to LVC unit. Turn on power to LVC input. Measure voltage across black and white input leads. Incorrect wiring. Recheck all wiring for proper installation.
Single Motor Low Voltage Control (LVC) SPECIFICATION DATA SUGGESTED SPECIFICATIONS: Electrical rating 115 VAC 60 Hz 5A. The single motor LVC is used to operate Da-Lite single motor electric screens from one or more locations, remote control, or for integration into a control panel system. Operated by a 3-button momentary, dry contact switch.
PRODUCT NOTES WHEN ORDERING, MARK APPROPRIATE SELECTIONS: • This control cannot be used with the Horizon Electrol®, Ascender® Electrol®, Dual Masking Electrol® or Motorized Scenic Roller screens. 1. Select optional accessories: • Specifications are subject to change without notice. Radio Frequency Remote Control. Radio Frequency Range Extender available Infrared Remote Control. Additional 3-button Wall Switch. 240V Model Available. Key Locking Cover Plate for 120V or Low Voltage Control (LVC).
