INSTRUCTION BOOK FOR Advantage® Deluxe Electrol®
Important Safety Instructions Pre-Installation When using your video equipment, basic safety precautions should always be followed, including the following: 1. 1. 2. Make sure to recheck measurements of screen location before installation. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. Carefully unpack screen and remove outer wrapping from case. 3.
Screen And Roller Assembly Installation If your screen was shipped with the motor and roller already installed proceed to step 6. 1. Remove the screw from each end of the access door (front door) and open the door. See figure 1. 2. Carefully unpack screen and roller assembly. Leave packing paper on the roller. 3. Place the roller assembly into the case with the motor on the left side. The limit switches should be facing down. Line up the square pin on the motor with the square hole in the bracket. 4.
Screen Adjustment NOTE: Use a screw driver or 5/32" Allen wrench to make adjustments. More Screen Drop 1. Place operating switch in “down” position. 2. When the screen stops, turn the white “down” limit knob (Fig. 2) one-quarter turn counterclockwise. Test by raising picture surface approximately two feet, then lower again. Repeat until desired picture surface position is attained. CAUTION: Do not adjust for more drop than what was ordered. At least 1-1/2 wraps of fabric must remain on the roller.
Advantage® Deluxe Electrol® Instructions For Standard Control 120V Wiring Diagram NOTE: Electrical connections on left end of case.
Advantage® Deluxe Electrol® Instructions SCB-100 Control 120V Wiring Diagram Power Input and Control Board are Located on Right Side of Screen Housing.
Advantage® Deluxe Electrol® Instructions SCB-200 Control 120V Wiring Diagram Power Input and Control Board are Located on Right Side of Screen Housing.
Advantage® Deluxe Electrol® Installation 7 1/4" 7 1/4" Case Length Variable Position Mounting Brackets 61 /8" Flat Bar Mounting Method Motor End 9 1/4" Electrical Junction Box 6 1/8" (Suggested) 3/8" Threaded Rod (Not Included) Attached to Mounting Bracket 7 1/4" Finished Ceiling Self-Trimming Flange 8 3/4" See Detail A Formed Bracket Mounting Method 4.59" (Suggested) 3/8" Threaded Rod (Not Included) 7.21" Hanger Bracket Detail A 8 8.75" 8.
Troubleshooting Visit www.da-lite.com to find installation and troubleshooting tutorials. You will also find a link to Live Chat for interactive support and you can contact us by email at info@da-lite.com or by phone at (800) 622-3737 or (574) 267-8101 with any troubleshooting questions. Symptom Cause Solution If screen is not responding properly and SCB100 or SCB200 controls are used, contact the factory for troubleshooting assistance. Incorrect line voltage. Verify 115-125V (or 220-240V).
Troubleshooting Symptom Cause Solution Hinge is bound or has a foreign substance on it which does not allow it to open by gravity. Check installation to free door. Clear any foreign substance; i.e., paint or plaster from hinge. No power. See above. Open door limit switch. Replace switch. No power from screen motor. Replace screen motor “Down” limit switch incorrect.. “Down” limit switch out of adjustment. See installation instructions. Noise.
LIMITED ONE YEAR WARRANTY ON DA-LITE PRESENTATION PRODUCTS Milestone AV Technologies LLC warrants certain Da-Lite branded products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; provided they are properly operated according to Da-Lite’s instructions and are not damaged due to improper handling or treatment after shipment from the factory.
