INSTRUCTION BOOK FOR Special Needs Lecterns
All Models Power Height Adjustment Connect power supply to 110/120 VAC 3-wire outlet (220/240 VAC models to 220/240 VAC source). The reading surface adjustment is controlled by the switch marked HEIGHT and provides 8 – 9 inches of elevation. To raise or lower, depress HEIGHT switch. Digital Clock/Count Down Timer Select desired mode; adjust time with SET switch. Unit will remain operational as long as the main power supply is on. NOTE: Power interruptions will cause the clock to flash until reset.
Digital Clock-Timer Set Mode Minute Clock Hour Timer Main MIC. AUX MIC. AUX Line Bass Height Treble Speaker Up On Down Off Service The Da-Lite sound system is modular in design for ease of service. The power supply and amplifier are accessed inside the lectern body. If your lectern fails to operate on a known power source, be sure to check the circuit breaker located on the Power Supply for a tripped condition. Reset to restore function.
Lectern Wiring Diagram – Non-Sound System Wire Nut Dash Panel (Rear View) Height Adj. Switch Wire Nut Digital Clock Clock/Timer Switch On Off On T1 120 VAC Only Conn. 3 CIR. Fast/Slow Switch Conn. 3 CIR. Wire Code Green Blue Orange Brown Yellow Black White Red Conn. 3 CIR. Conn. –3 CIR.
Lectern Wiring Diagram – Sound System Preamp/Mixer Assembly Mic 1 Ribbon Cable 20 Com Motherboard Full + Tweeter High Clock 3-Pin Jack External Speakers Speaker Switch 20 Amplifier Assembly 1 1 + Dash Panel Circuit Housing Woofer AC Out SW.
LIMITED ONE YEAR WARRANTY ON DA-LITE PRESENTATION PRODUCTS Milestone AV Technologies LLC warrants certain Da-Lite branded products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; provided they are properly operated according to Da-Lite’s instructions and are not damaged due to improper handling or treatment after shipment from the factory.
