INSTRUCTION BOOK FOR Lectern
All Models Optional Height Adjustment Power Models with optional reading surface adjustment are controlled by the switch marked HEIGHT and provide up to 8 - 9 inches of elevation. To raise or lower, depress HEIGHT switch. Connect power supply to 110/120 VAC 3-wire outlet (220/240 VAC models to 220/240 VAC source). Reading Light Depress light switch to activate light. ADJUST VISOR AS NECESSARY.
Sound Models Plug microphone into shock mount on reading surface. Turn main power switch located under reading surface on. Rotate "MAIN MIC", "TREBLE" and "BASS" controls fully counterclockwise to minimum volume position. Turn speaker switch located on dash panel to "on" position. While speaking into the microphone, slowly increase "Main Mic" volume by turning knob clockwise. Adjust until feedback begins, then decrease volume to stable condition or lower to desired volume level.
Lectern Wiring Diagram – Non-Sound System To Light Dash Panel (Rear View) Wire Nut Height Adj. Switch (Optional) Light Switch Conn. –2 CIR. Wire Nut Digital Clock T1 Clock/Timer Switch On Off On 120 VAC Only Conn. 3 CIR. Fast/Slow Switch Conn. 3 CIR. Conn. 3 CIR. Wire Code Green Blue Orange Brown Yellow Black White Red (Optional) Conn. –3 CIR.
Lectern Wiring Diagram – Sound System Clock 3-Pin Jack External Speakers Speaker Switch + Preamp/Mixer Assembly Mic 1 Ribbon Cable 20 Tweeter Com Full High Motherboard 20 Amplifier Assembly 1 1 + Dash Panel Circuit Housing Woofer AC Out SW.
LIMITED ONE YEAR WARRANTY ON DA-LITE PRESENTATION PRODUCTS Milestone AV Technologies LLC warrants certain Da-Lite branded products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; provided they are properly operated according to Da-Lite’s instructions and are not damaged due to improper handling or treatment after shipment from the factory.
