The Da-Lite Difference. Instruction Book for Cosmopolitan® Electrol® For Sizes Up To 9'x12' DA-LITE SCREEN COMPANY, INC. 3100 North Detroit Street Post Office Box 137 Warsaw, Indiana 46581-0137 Phone: 574-267-8101 800-622-3737 Fax: 574-267-7804 Toll Free Fax: 877-325-4832 www.da-lite.com e-mail: info@da-lite.
IMPORTANT SAFETY INSTRUCTIONS When using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3. If an extension cord is necessary, a cord with a current rating at least equal to that of the appliance should be used. Cords rated for less amperage than the appliance may overheat. 4.
COSMOPOLITAN® ELECTROL® INSTALLATION Overall length A=fabric width + 8". Length B is the distance between wall mounting holes at back of end caps and is the fabric width + 6-1/2". 3/4" DIAMETER HOLE FOR WALL INSTALLATION MOTOR END 423⁄32" 1 ⁄32" 29 ⁄32" 5 A 3 ⁄8" DIAMETER FOR CEILING INSTALLATION B 63⁄32" 57⁄8" ENCLOSURE COVER 4" ⁄8" DIAMETER KNOCK OUT 7 ⁄8" DIAMETER OPENING FOR ELECTRICAL FITTINGS 7 1 ⁄16" 3 4" FABRIC HEIGHT x WIDTH AS ORDERED, UP TO 12 FEET x 12 FEET.
SCREEN ADJUSTMENT FOR SCREENS WITHOUT A BUILT-IN LOW VOLTAGE CONTROL Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly adjusted at DA-LITE. Should it be necessary to adjust for more or less picture drop (viewing area), proceed in the following manner: NOTE: Use a screwdriver or 5/32" Allen wrench to make adjustments.
COSMOPOLITAN® ELECTROL® INSTALLATION RJ-14 PIN-OUTS 120V WIRING DIAGRAM WITH OPTIONAL BUILT-IN LOW VOLTAGE CONTROL RJ-22 PIN-OUTS (TAB IS FACING UP) (TAB IS FACING UP) +12V BUS (RP DATA) WHITE BUS (RP DATA) RQ DATA +5V GND GREEN RED BLACK RQ DATA +5V GND RQ CLOCK RJ-22 JACK Supplied RJ-14 cable RJ-22 OUTPUT UP LIMIT TACTILE BUTTON RJ-22 JACK UP DRY CONTACTS BUS RJ-45 RECEPTACLE RJ-45 JACK 5V COM BUS DOWN LIMIT TACTILE BUTTON FRONT OF WALL SWITCH BUS (TAB IS FACING UP) MANUAL 2 +12V B
COSMOPOLITAN® ELECTROL® INSTALLATION 240V WIRING DIAGRAM WITH OPTIONAL BUILT-IN LOW VOLTAGE CONTROL OPTIONAL IR AND RF REMOTE CONTROL CONNECT SUPPLIED RJ9 CABLE TO SPLITTER AND SWITCH, OR USE 4 CABLE CONDUCTOR TO CONNECT TO SCREW TERMINALS.
TROUBLESHOOTING Visit www.da-lite.com/products/tutorials.php to find installation and troubleshooting tutorials. You will also find a link to Live Chat for interactive support and you can contact us by email at info@da-lite.com or by phone at (800) 622-3737 or (574) 267-8101 with any troubleshooting questions. Symptom Cause Solution 1. Screen will not operate. Motor does not hum. (a) Incorrect line voltage. (a) Verify 115-125V (or 220-240V). If insufficient voltage, rewire incoming electric line.
LIMITED ONE YEAR WARRANTY ON DA-LITE PRESENTATION PRODUCTS Da-Lite Screen Company, Inc. warrants its products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser provided they are properly operated according to Da-Lite’s instructions and are not damaged due to improper handling or treatment after shipment from the factory.
