The Da-Lite Difference. Instruction Book for DESIGNER ELECTROL® 3100 North Detroit Street Post Office Box 137 Warsaw, Indiana 46581-0137 Phone: 574-267-8101 800-622-3737 Fax: 574-267-7804 Toll Free Fax: 877-325-4832 www.da-lite.com e-mail: info@da-lite.
IMPORTANT SAFETY INSTRUCTIONS When using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3. If an extension cord is necessary, a cord with a current rating at least equal to that of the appliance should be used. Cords rated for less amperage than the appliance may overheat. 4.
PRE-INSTALLATION Before proceeding with the installation of the screen, please read the installation and operations instructions thoroughly! ! s CAUTION! Do not cut wrapping paper or tape with knife or any sharp tool. Pull orange string. 1. Carefully unpack the screen and remove the outer wrapping. 2. Always handle screen in upright position. 3. Remove the front cover of the screen from the back of the screen. Lift front cover up approximately 1/2" and pull away from back of screen. See Figure 1. 4.
DESIGNER ELECTROL® INSTALLATION 1. Hang screen from wall or ceiling.
DESIGNER ELECTROL® INSTALLATION 120V WIRING DIAGRAM EXTERNAL WIRING TO BE COMPLETED BY INSTALLER. MOTOR BLACK RED UP ROCKER SWITCH BLACK DOWN SIDE VIEW OF SWITCH AND BOX RED WHITE COMMON TO JUNCTION BOX MOUNTED IN SCREEN CASE, IN WHICH INTERNAL WIRING TERMINATES IN WHITE, BLACK AND RED LEADS. DOWN WHITE LIMIT SWITCH KNOB OPERATING SWITCH, SWITCH BOX, AND PLATE FURNISHED WITH SCREEN. (SPDT WITH CENTER OFF) AC COMMON AC HOT UP OFF DOWN BLACK WITH YELLOW 120 VOLTS 50/60 HZ. 2.5 MAX. AMP.
TROUBLESHOOTING Symptom Cause Solution 1. Screen will not operate. Motor does not hum. (a) Incorrect line voltage. (a) Verify 115-125V (or 220-240V). If insufficient voltage, rewire incoming electric line. (b) Replace fuse. (c) Reset circuit breaker. (d) Check above. Tighten all loose wire connections. Correct any improper connections. “Down” Position Check for power across black and white leads. “Up” Position Check for power across red and white leads. (b) Blown fuse.
6
LIMITED ONE YEAR WARRANTY ON DA-LITE PRESENTATION PRODUCTS Da-Lite Screen Company, Inc. warrants its products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser provided they are properly operated according to Da-Lite’s instructions and are not damaged due to improper handling or treatment after shipment from the factory.
