Owner's manual

4
Installing the High Voltage Switch Control (Standard)
Three standard 3-position wall switches are supplied. The high-voltage control is connected to the electrical source.
It alternates directions of mask motion by means of a hot lead, using the 3-position switches.
Multi-Mask Imager Installation
Down Red Up Black
Common White
Black With
Yellow
Black
White
Red
Up
Down
Rocker
Switch
AC Common
AC Hot
Operating Switch,
Switch Box, And
Plate Furnished
With Screen
(SPDT With
Center Of)
120V. 60HZ 2.5 Max. Amp
To Motor
In Multiple Control
Installations This Switch
Is Replaced By The Low
Voltage Control,
Operated From Push
Button Stations.
This Switch Cannot Be Used With LVC.
NOTE: A single switch cannot be used to operate more than
one screen. Contact the factory for further information.
Side View
Of Switch
And Box
120V Wiring Diagram
220 / 240V
Wiring Diagram
Brown (Up)
Black (Down)
Blue (Common)
Brown/Yellow
Up
Of
Down
Rocker
Switch
Blue AC Common
Brown AC Hot
Operating Switch,
Switch Box, And
Plate Furnished
With Screen.
Blue Jumper Wire
To Motor
NOTE:
Must Be Wired To Conform To
Local Wiring Code. This Switch
Cannot Be Used With L.V.C.
220/240V. AC 50HZ
2 Amp. Max
Junction
Box
In Multiple Control
Installations This Switch Is
Replaced By The Low
Voltage Control, Operated
From Push Button Stations.
NOTE: A single switch cannot be used to operate more than
one screen. Contact the factory for further information.
Rear View Of DPDT,
With Center Of
Of