INSTRUCTION BOOK FOR Computer Table Netbook Storage Cart CT-NS42
Tools Required for Installation CAUTION! The user of this product should exercise caution when moving the cart. Any sudden stop could cause instability of the cart and could cause serious injury and/or damage. The cart should always be pushed, never pulled, by the user. Always push from the side of the cart, never from the front or back of the cart. This cart is rated 115 VAC, 60 Hz 12 A.
Suggested Methods of Installation (Continued) 2. Lay cart onto rear panel. See Figure 1. Install Plate Casters. Two casters have wheel brakes and two casters have swivel locks. Install both wheel brake casters on one end and both swivel lock casters on the other end. It does not matter onto which end either pair of casters is mounted. Tighten all fasteners. 4. Remove rear panel by turning the fasteners 1/4 turn in either direction. Route the Power Cord through the shelves and out through either side.
Suggested Methods of Installation (Continued) 6. The control panel is shown. See Figure 6. The ON/OFF switch is also a 15A circuit breaker. The Arrow Keys allow you to select the Mode. If you want to use the Auxiliary Receptacles, push the Arrow Keys to select the Auxiliary Mode. No netbook charging occurs when the Auxiliary Mode is selected. The Auxiliary Receptacles are rated for 120VAC, 12A. Select another MODE to turn the Auxiliary Receptacles off.
Suggested Methods of Installation (Continued) 9. You may experience problems when charging if only a few computers are on one shelf, especially if they are only partially discharged. The computers may not draw enough electrical current to indicate to the power distribution device that there are computers on the shelf. There are solutions to this problem.
A Milestone AV Technologies Brand 3100 North Detroit Street Warsaw, Indiana 46582 P: 574.267.8101 or 800.622.3737 F: 574.267.7804 or 877.325.4832 E: info@da-lite.com www.da-lite.com DL–0388 6.14 © 2014 Milestone AV Technologies LLC. Printed in U.S.A.
