INSTRUCTION BOOK FOR Computer Table Tablet Storage Cart CT-TS32 & CT-TS48
Tools Required for Installation CAUTION! The user of this product should exercise caution when moving the cart. Any sudden stop could cause instability of the cart and could cause serious injury and/or damage. The cart should always be pushed, never pulled, by the user. Always push from the side of the cart, never from the front or back of the cart. This cart is rated 115VAC, 12A.
Procedure (Continued) 4. Install the USB cords (supplied with the computer) for each tablet computer. See Figure 3. Open each drawer. Insert the USB cord into any available USB port on the Charging Board. Pass the other end of the USB cord through the round Grommet at the front of the drawer and let it hang just above the shelf. Wrap excess cord around the Cord Cutouts. 2. Lay cart onto rear panel. See Figure 1. Install Stem Casters. 4 5 USB Cord Supplied With Tablet Figure 1 3. Install Mats into cart.
Procedure (Continued) 5. Charging computers. Rocker Switch should be off. See Figure 4. Turn off computers and place computers into cart. Insert USB cord into computer’s USB port. Flip Rocker Switch on to start charging. 6. Syncing computers. Rocker Switch should be off. See Figure 4. Turn off tablet computers and place computers into cart. Insert USB cord into the computer’s USB port. Connect the master laptop computer to the cart’s USB port using the USB cord supplied with cart. Turn on master laptop.