Installation instructions
2
IMPORTANT SAFETY INSTRUCTIONS
When using your video equipment, basic safety precautions should always be followed, including the following:
1. Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over,
pulled, or contact hot surfaces.
3. If an extension cord is necessary, a cord with a current
rating at least equal to that of the appliance should be
used. Cords rated for less amperage than the appliance
may overheat.
4. To reduce the risk of electric shock, do not disassemble
this appliance. Contact an authorized service dealer when
repair work is required. Incorrect reassembly can cause
electric shock when the appliance is used subsequently.
5. The use of an accessory attachment not recommended
by the manufacturer may cause a risk of fire, electric
shock, or injury to persons.
1. Carefully unpack screen and remove outer wrapping
from case.
2. Set aside the Installation Kit. Items inside will be used during
installation.
NOTE: Carefully unpack screen. Use supplied 1/8" hex key and #2
phillips screwdriver to remove silver shipping brackets attached to
slat and screen case.
There are three ways to install the Tensioned Contour Electrol —
Wall Mount, Ceiling Mount, or Ceiling Hook. Procedures for each
method are as follows:
WALL MOUNT
1. Using a #2 Phillips screwdriver, loosen the two stop screws
and remove the wall mount bracket from the back side of the
case (Figure 1).
NOTE: The ceiling flush mount and ceiling hook mount brackets
are attached to the top side of the case. These brackets are not
necessary for wall mounting and can be removed at this time.
2. Secure the wall mount bracket to the wall at the desired height.
The wall mount bracket should be fastened to the wall studs or
some reinforcement within the wall. Concrete or brick walls
require special fasteners and anchors. Allow at least 2-3/8”
above the wall mount bracket to be able to position the case on
the bracket (Figure 2).
INSTALLATION
PRE-INSTALLATION
Figure 1
TOOLS REQUIRED FOR INSTALLATION
#2 Phillips Screwdriver
2-5/16"
5-11/16"
2-9/16"
6-3/8"
Case Hook
Slat Bar
Wall Mount
Bracket
Stop Screws
1/8” Hex Key
(included)