The Da-Lite Difference. Instruction Book for Tensioned DUAL MASKING Electrol® DA-LITE SCREEN COMPANY, INC. 3100 North Detroit Street Post Office Box 137 Warsaw, Indiana 46581-0137 Phone: 574-267-8101 800-622-3737 Fax: 574-267-7804 Toll Free Fax: 877-325-4832 www.da-lite.com e-mail: info@da-lite.
IMPORTANT SAFETY INSTRUCTIONS When using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3. If an extension cord is necessary, a cord with a current rating at least equal to that of the appliance should be used. Cords rated for less amperage than the appliance may overheat. 4.
PRE-INSTALLATION 1. Carefully unpack screen and remove outer wrapping from case. 2. Make sure to recheck measurements of screen location before installation. 3. Remove center support brackets (on 8' and wider screens only), reverse brackets and reinstall flush with the top of the box. mask motor mask surface Drywall Screw Access Panel Machine Screw PHILLIPS HEAD Screw SHIPPING BRACKET HEX HEAD Screw PICTURE SURFACE screen motor FIGURE 1 FIGURE 2 INSTALLATION 1.
SCREEN ADJUSTMENT ! s ! s Caution! The mask should not be field adjusted for more Or less drop. Contact Da-Lite at 800-622-3737 or 574-267-8101 if screen motor needs adjustment. TENSIONED Dual Masking ELECTROL® INSTRUCTIONS 115V DUAL MOTOR CONTROL black up black red Down RED common white common white ground green ground green uP down 4 – wire mask motor 4 – wire screen motor mask screen up up off Mask motor Down Screen motor down 115V. A.C.
TENSIONED Dual Masking ELECTROL® INSTRUCTIONS 220V DUAL MOTOR CONTROL up Brown up Brown down Down Black common Black Blue common Blue ground green ground green 4 – wire mask motor 4 – wire Screen motor mask screen up up off Mask motor Screen motor Down down 220V. A.C.
SUGGESTED METHODS OF INSTALLATION METHOD A METHOD B 9-3/16" 9" (SUGGESTED) 1/4" Lag Screws Mounting Bracket 9-3/16" (SUGGESTED) 1/4" Lag Screws 1-1/2" 9" Mounting Bracket 1-1/2" 1-1/2" 1-1/2" Mounting Joist Mounting Joist 8-11/16" Furring Strip 3/4" finished Ceiling 3-1/2" paneL 3/4" finished Ceiling 3-1/2" panel Ceiling Tile Cut to 1/4" THICK (ATTACH with mastic) Picture Surface Masking Surface Can be painted same as ceiling or removed and replaced with finished ceiling ALUMINUM slat
TROUBLESHOOTING Visit www.da-lite.com/products/tutorials.php to find installation and troubleshooting tutorials. You will also find a link to Live Chat for interactive support and you can contact us by email at info@da-lite.com or by phone at (800) 622-3737 or (574) 267-8101 with any troubleshooting questions. Symptom Cause Solution 1. Screen will not operate. Motor does not hum. (a) Incorrect line voltage. (a) Verify 115-125V (or 220-240V).
LIMITED ONE YEAR WARRANTY ON DA-LITE PRESENTATION PRODUCTS Da-Lite Screen Company, Inc. warrants its products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser provided they are properly operated according to Da-Lite’s instructions and are not damaged due to improper handling or treatment after shipment from the factory.
