INSTRUCTION BOOK FOR Tensioned Large Dual Masking Electrol
Important Safety Instructions When using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3. If an extension cord is necessary, a cord with a current rating at least equal to that of the appliance should be used. Cords rated for less amperage than the appliance may overheat. 4.
Installation NOTE: Unit is not to be installed in air handling space. Hangers (If required) 1. Make sure hangers are placed to fit into the pre-determined notches. 2. Level unit lengthwise with a carpenter’s plum level. CAUTION! Do not completely seal in unit. Access room must be allowed for motor repair or fabric replacement. 6. Test installation by carefully running surface up and down several times. Be prepared to stop screen. Standard Duty Cycle: 1 MIN. ON / 10 MIN. OFF.
Tensioned Large Dual Masking Electrol® Instructions Junction Box Located in Screen Housing 120V Wiring Diagram Up Down Common Ground Junction Box Located in Screen Housing Black Red White Green Black Red White Green 4 – Wire Mask Motor 4 – Wire Screen Motor Mask Mask Motor Up Down Common Ground Screen Up Up Off Off Down Down Screen Motor Protective Earthing Stud Inside Junction Box Double Gang J-Box Provided By Da-Lite Black (Hot) White (Common) Ground Wire IMPORTANT NOTE: 115 V.
Tensioned Large Dual Masking Electrol® Instructions 191⁄2" 111⁄2" Mounting Bracket (3 Provided) Electrical Outlets Motor End SUGGESTED METHODS OF INSTALLATION NOTE: Unit is not to be installed in air handling space. Ceiling Type Hanger Wall Type Hanger Rafters Picture Surface Picture Surface Picture Surface Wall or Ceiling Mount With Hangers Wall type hangers and ceiling type hangers are standard equipment. One set is supplied with each screen. Useful for recessed installations.
Troubleshooting Symptom Cause Solution Incorrect line voltage. Verify 115-125V (or 220-240V). If insufficient voltage, rewire incoming electric line.. Branch circuit fuse blown. Replace fuse. Tripped branch circuit breaker. Reset circuit breaker. Check above. Tighten all loose wire connections. Correct any improper connections. “Down” Position No power to operating switch or junction. creen will not operate S and motor does not hum. “Up” Position Check for power across red and white leads.
LIMITED ONE YEAR WARRANTY ON DA-LITE PRESENTATION PRODUCTS Milestone AV Technologies LLC warrants certain Da-Lite branded products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; provided they are properly operated according to Da-Lite's instructions and are not damaged due to improper handling or treatment after shipment from the factory.
