The Da-Lite Difference. Instruction Book for tensioned professional Electrol® DA-LITE SCREEN COMPANY, INC. 3100 North Detroit Street Post Office Box 137 Warsaw, Indiana 46581-0137 Phone: 574-267-8101 800-622-3737 Fax: 574-267-7804 www.da-lite.com e-mail: info@da-lite.
IMPORTANT SAFETY INSTRUCTIONS When using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3. If an extension cord is necessary, a cord with a current rating at least equal to that of the appliance should be used. Cords rated for less amperage than the appliance may overheat. 4.
PRE-INSTALLATION 1. Carefully unpack screen. 2. Make sure to recheck measurements of screen location before installation. 3. Remove instruction cover plate (Fig. 1). Do not remove wrapping paper until screen is installed. 4. Remove the retainer screws from the slat bar before the case has been installed (Fig. 2). (3 SCREWS) 1 ON BOTTOM OF SLAT 2 ON INSIDE OF CASE INSTRUCTION COVER CASE SLAT RETAINER BRACKET FIGURE 1 FIGURE 2 INSTALLATION Hangers (If required) 1.
TENSIONED PROFESSIONAL ELECTROL® INSTALLATION 9-1/2" 11-5/16" Reinforced Top Motor End Electrical Outlet Box SUGGESTED METHODS OF INSTALLATION CEILING TYPE HANGER RAFTERS 2" MOULDING PICTURE SURFACE PICTURE SURFACE 1" x 3" CLEAT PICTURE SURFACE WALL TYPE HANGER CEILING MOUNT WITHOUT HANGERS Screen case is placed flush with the wall and ceiling and held in position by moulding securely attached to the wall.
TENSIONED PROFESSIONAL ELECTROL® INSTALLATION 120V WIRING DIAGRAM RED (UP) BLACK (DOWN) WHITE (COMMON) GREEN (GROUND) WHITE (COMMON) RED (UP) BLACK (DOWN) BLACK (DOWN) To Junction box MOUNTED IN SCREEN CASE, IN WHICH INTERNAL WIRING TERMINATES IN WHITE, BLACK, AND RED LEADS. IN MULTIPLE CONTROL INSTALLATIONS THE SWITCH IS REPLACED BY THE LOW VOLTAGE CONTROL, OPERATED FROM PUSH BUTTON STATIONS. GREEN (GROUND) UP AC COMMON OFF AC HOT 115V. AC 60HZ 1 AMP. MAX.
TROUBLESHOOTING Visit www.da-lite.com/products/tutorials.php to find installation and troubleshooting tutorials. You will also find a link to Live Chat for interactive support and you can contact us by email at info@da-lite.com or by phone at (800) 622-3737 or (574) 267-8101 with any troubleshooting questions. Symptom Cause Solution 1. Screen will not operate. Motor does not hum. (a) Blown fuse. (b) Tripped circuit breaker. (c) No power to operating switch or junction. (a) Replace fuse.
THIS PAGE IS INTENTIONALLY LEFT BLANK 6
LIMITED ONE YEAR WARRANTY ON DA-LITE PRESENTATION PRODUCTS Da-Lite Screen Company, Inc. warrants its products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser provided they are properly operated according to Da-Lite’s instructions and are not damaged due to improper handling or treatment after shipment from the factory.
