Repair Manual

STARTING AND CHARGING
16
16 - 12
R
EMUONTING
Remount :
- the end bearing and the stator;
- the front bearing;
- the attachment screws;
- the pulley wedge;
- the fan and the pulley;
- the snap ring and the pulley fixing nut;
- the brushes support;
- the voltage regulator ( for alternator type 1180 ).
Check the alternator on the bench.
Mount the alternator on the vehicle.
Connect the battery.
NOTE:
Tightening moment: - for the pulley nut 3 – 3,5 daNm ( for type 1114.200) or 7 daNm
( for type 1180 );
- terminal ( B + ) : 0.3 da Nm.
The belt shall be tighten to obtain a maximum arrow of 7,5 mm for a pushing force
of about 3 daNm,at half distance between the water pump pulley and the alternator
pulley. Exaggerate tensioning of the belt may lead to the premature wear of the both
alternator bearings and water pump bearings.
For additional informations ,please see Chapt. 07.
ALTERNATOR
vnx.su