Repair Manual

16
STARTING AND CHARGING
16 - 27
FORK STROKE ADJUSTMENT
Dismount the protector from the solenoid end.
Check the clearance (F) between the screw and the adjustment nut, which must be as
small as possible. In this situation the coupling mechanism ( bendix ) must be leaning on
the rotor.
Check if clearance (H) is between 1 + / - 0,5 mm.
For adjustment act on the adjustment nut ( 1 ) until clearances F and H are correct.
By loosening the nut the clearance ( H ) is reduced.
NOTE:
When mounting/remounting the 2600 type starter, it is forbidden its hitting with the
hammer of some other hard thing which might cause the breaking of the stator
magnets.The maintenance operations are to be performed on a clean table in order to
avoid deposing of iron scraps or metallic parts on magnets.
STARTER
vnx.su