Repair Manual

CLUTCH
20
PRESSURE BEARING REPLACEMENT
D
ISMOUNTING
Dismount the gearbox. from the vehicle.
Release the spring from the pressure bearing ears.
Dismount the pressure bearing.
R
EMOUNTING
Grease the bearing guide and the clutch
forks ends with grease UM 170 Li Ca Pb 2M.
Place the new bearing.
Place the spring by introducing the ends
in the bearing holes.
Slightly grease the contact surface
between the diaphragm and the bearing with
grease UM 170 Li Ca Pb 2M.
Remount the gearbox.
Adjust the clutch stroke (2,5 - 3,5 mm at
the end of control lever).
20 - 4
CLUTCH DISK – MECHANISM
vnx.su