Repair Manual

MANUAL GEARBOX
21
21 - 15
Place the new elastic pins.
The pins notches shall be oriented towards the wheel. The ends of the pins shall be
sealed with RHODORSEAL 5661.
Mount (on both sides):
a. the upper suspension joint
b. the steering joint
Mount the front wheels, take the vehicle down from the elevator and tighten the wheels
nuts at the required moment (9 daNm).
Dismount the TF 509 support cross bar.
Mount the clutch cable with its support.
Adjust the clutch stroke (2,5 – 3,5 mm to the end of shifter shaft).
Adjust the velocity steps gearing.(see chapt.” Velocity steps control adjustment “).
Mount the starter and the protection shield.
Connect :
- the starter power cable ;
- the coupling relay supply wire.
Fill up the gearbox with oil SAE 80/90 ; API GL 5. .
Check the velocity steps gearing.
Connect the battery.
DISMOUNTING - REMOUNTING
vnx.su