Repair Manual

MANUAL GEARBOX
21
21 - 32
Mount the differential bearings on a press.
ADJUSTMENT OF THE CONICAL DISTANCE (G.B.365 AND 51 C)
The differential drive pinion is in the
correct position, when its front is at distance
A=59 mm from the toothed crown axis.
This position is obtained by mounting a
washer (1) of the adequate thickness between
the biconical bearing (2) and the differential drive
pinion shoulder(3).
CAS EXCEPTIONEL
There may be situations when the value A=59
mm is not correct value for the pinion positioning.
The difference (X) between the actual
value and the value A=59 mm is marked on the
front side of the pinion near the number marked
for pairing with the toothed crown.
The value is given in hundredths of mm.
E
XAMPLE : X = 20 (0,2 mm)
In this situation ,the distance between the
conical mechanisms shall be A + X. In a.m.
case:A +X = 59 + 0,2 = 59,2 mm
REPAIR
vnx.su