Repair Manual

MANUAL GEARBOX
21
21 - 36
Notice the nuts position corresponding to
the half crankcases.
Dismount the left side half crankcase and
the differential gear.
REMOUNTING OF FORKS AND SHAFTS
Mount the reverse driving shaft in the right side half crankcase.
Position the reverse drive selector in the notch of the reverse driving shaft.
Tighten at the required couple ( 2,3 daNm ) the reverse driving selector shaft.
Place the attachment spring and ball of the velocity steps I -II fork shaft.
Introduce the shaft.
Assembly the velocity s teps I -II fork with the hub, towards the back side of the gearbox.
Introduce the elastic pin.
REPAIR
NOTE:
Upon remounting, the elastic pins shall be positioned with the slot towards the back
side of the gearbox.
vnx.su