Repair Manual

MANUAL GEARBOX

21 - 40

Place the following parts on the

secondary shaft:

- the velocity step V pinion;

- the elastic washer;

- the speedometer endless.

Check the clearance “J” between the

synchronizing ring and the surface of the hub : J

= min 0,2 mm

The checking shall be performed as follows:

- the pinion in contact with the hub;

- the synchronizing ring in contact with

the pinion con.

Couple the reverse driving and the velocity

step V.

Tighten at the required couple:

REPAIR

- the nut of the primary shaft: 6 daNm

- the speedometer endless screw: 10 - 12 daNm ( G.B. 365).

Secure the locking nut and the speedometer endless screw.

GEAR CLEARANCE ADJUSTMENT (G.B. 365,51C)

In order to adjust the clearance of the gear, loosen the nut (1) from the right side half

crankcase and tighten the nut (2) from the left side half crankcase by the same value.

vnx.su