Repair Manual

MANUAL GEARBOX
21
21 - 41
Mount a comparing device on the
crankcase and place the feeler perpendicularly
on the crown tooth flank, as much to the edge of
the rim as possible.
Check the clearance of the gear which
should be: 0,12-0,25 mm.
Adjust the nuts until correct clearance is
obtained.
Mount the nuts locks.
.
BACK CAP ASSEMBLING
Mount the control shaft annular oil seal.
Assemble the rocking lever with its shaft.
Mount together:
- the assembled rocking lever shaft;
- the control shaft.
Tighten the attachment nut of the return
rocking lever (4-4,5 daNm).
Mount the rubber protection.
Mount on the control shaft:
- the protection bellows;
- the control shaft end;
- the elastic pin.
REPAIR
vnx.su