Repair Manual

MANUAL GEARBOX
21
21 - 43
CLUTCH CASING RE MOUNTING
Press in the clutch casing the guiding bushing of the pressure bearing (only if it has
previously been dismounted).
Mount the annular oil seal of the clutch shaft by means of the device CV 488.
NOTE: Before mounting, the annular oil seal shall be immersed in 80W/90.
Apply a layer of sealing paste LOCTITE 518 on the assembling area of the clutch casing
REMOUNTING THE COUPLING MECHANISM 4X4 (G.B. 51 C)
Check by visual inspection the state of the
mechanism elements and replace
damaged parts with new ones.
Mount the pins housing (13) and the claw
(12).
Mount using a press, by means of a metallic
strap, the bearing on the differential hub (if this
was previously dismounted).
Mount the assembly hub - the tooth gear
sliding mechanism (10), together with coupling
shaft and fork (11 ).
Place the washer rut (9).
Mount the safety ring (8) on the propeller shaft
pinion.
Mount the cover (7).
REPAIR
with mechanisms crankcase.
Mount the clutch casing by means the device
CV 488 for oil seal ring protection.
Tighten the attachment screws of the clutch
casing at the required moment.
M8 : 2 - 2,8 daNm
M10 : 3,2 - 4 daNm
Mount the reverse lamp contact, after its
thread has been greased with LOCTITE 577
and tighten it at required moment
(2,5 daNm).
12
11
13 10
9
8 7
vnx.su