Repair Manual

VALUES AND SETTINGS
07
07 - 6
DRIVING BELTS TIGHTENING AND TIGHTENING CHECKING
* press on the device until the big “O” ring passes over the rule;
∗ read the value of force N on the scale with small “O” ring;
∗ compare the read value with the imposed value :
-if the N force value is within the imposed range, the belt tightening is good;
-if the read value is bigger or smaller than the imposed value, perform the
adjustment of the distance between pulleys axles ( re tighten the belt ), until obtaining a
value within the imposed range.
∗ start the engine, run it for five minutes, check again the belt tension and compare it
with the imposed value and adjust it if necessary;
∗ check the tension and correct if necessary the belts tightening at 1000 km compulsory
checking.
vnx.su