Repair Manual

DRIVE SHAFTS
29
FRONT CROSS TRANSMISSION
R
EMOUNTING
Grease the propeller shaft pinion grooves with Li Ca Pb type II.
Couple the transmission with the propeller shaft pinion.
Introduce the new elastic pins.
The pins notches shall be oriented towards
the wheel. The pins ends shall be sealed with
RODORSIL.
Introduce the transmission in the hub.
Mount the transmission in the hub by means
of the PF 236 device.
Mount:
- the suspension upper ball joint;
- the steering ball joint.
Tightening the nuts at the required couple.
Fix the hub by means of the PF 235 A device.
Mount:
- the washer ;
- the transmission nut.
Tighten the transmission nut at the required
moment.
Remount:
- the brake caliper;
- the wheel.
Take the vehicle down from the elevator and tighten the wheel nuts at the required
moment.
Dismount the PF 509 support cross bar.
Press the brake pedal several times in order to bring the brake piston in contact with the
friction linings.
NOTE:
If after front brake beginning the brake damage warning light remains on perform
the dismounting of the ICP from the brake pump; push three-five times the brake pedal
then remount the ICP and the brake damage warning light will not be on again.
29 - 4
vnx.su