Repair Manual

DRIVE SHAFTS

BELLOWS TOWARDS TO THE GEARBOX

GI 69 JOINT BELLOWS REPLACEMENT

Joint bellows replacement - the part towards the gearbox – is to be performed with

dismounted transmission.

1. Tulip

2. Assembled tripod

3. Assembled type

4. Casing

5. Collar

6. Bellows

7. Ruber ring

8. Transmission shaft

ISMOUNTING

Dismount the transmission off the

vehicle.

Dismount the collar (5) maintaining the

bellows (6) on the tulip.

Dismount the rubber ring (7).

Cut the bellows on the entire length.

Remove maximum possible of the

grease.

By means of a pair tongues, strain the

tulip tilt towards the outside in the three

zones of the tulip ramps.

Dismount the tulip.

Dismount the tulip safety ring.

Depress the tripod off the shaft.

NOTE:

The sliding blocks and the needles are in pairs. Do not dismount the sliding off the

tulip. Do not ever use solvent for parts washing.

29 - 5

vnx.su