Repair Manual

DRIVE SHAFTS
29
REMOUNTING
Grease, the transmission shaft, the bellows and the rubber ring with MoS 2 grease.
Place on the shaft, the rubber ring and the new bellows.
Mount the tulip on the shaft.
Mount the safety ring.
BELLOWS TOWARDS TO THE GEARBOX
Mount the tulip on the shaft.
Introduce approximate 14,0 cl special grease ELF CARDEXA or UM 185 Li 2 M in
the bellows and the tulip.
Introduce a bar between the bellows and the transmission shaft in order to dose the
quantity of air inside the bellows.
Move the tulip until the value A=162 mm is obtained ( the value comprised between
the bellows edge and the tulip extremity.
In this position take out the bar.
Mount the clip.
Mount the transmission on the vehicle.
29 - 6
vnx.su