Repair Manual

29
DRIVE SHAFTS
LONGITUDINAL TRANSMISSION ( CARDANIC )
IMPORTANT !
The cardanic joints forks which are mounted at the both ends of the longitudinal
transmission are to be placed in the same plane.
SIZE CHARACTERISTIS [ mm ]
Lt - total length of the cardanic transmission
L - lengt of the cardanic shaft with bearing
L z - length of the assembled cardanic shaft
V
EHICLE NUMBER OF LT L LZ
RANGE GEARS GB
DACIA 1304 4 TR 1970 870 1100
DACIA 1304 5TR 1950 850 1100
DACIA 1307 4 TR 2080 980 1100
DACIA 1307 5 TR 2060 960 1100
TIGHTENING MOMENTS [ daNm ]
- cardanic flanges tightening screws (extremities) - M 10 x 1,5................4 - 6
- cardanic intermediary flanges tightening screws - M 8 x 1,25...........1,5 - 2,5
CARDANIC TRANSMISSION MAINTENANCE
In order to avoid arising of same problems in exploitation such as : noise, joint clearance,
nooses gutter wear, it is necessary to perform the greasing of the cardanic transmission
every 5000 km.
The operation is performed within adjust in within the periodical technical revisions by
means of the Tecalemit (grease gun).
This to be applied on the lubricators from the joints areas (cross-head) and the
corresponding lubricator to the gutters. Needle roller bearings and the gutter connection is
to be lubricates under pressure using UM 185 Li 2 type grease or its equivalent.
Greasing is considered adequate when by the sealing elements (gaskets) the old grease
is eliminated and the new one is coming out.
The intermediary support does not require maintenance.
29 - 9
vnx.su