Repair Manual

31
FRONT BEARING ELEMENTS
31 - 13
BRAKE CALIPER
T
IGHTENING MOMENTS ( daNm )
Wheel nuts 9
Rigid sewerage-connection screws 1,5
DISMOUNTING
Drain the brake fluid tank.
Lift the vehicle by means of a two columns
elevator
Dismount the wheel.
Dismount:
-safety wedges;
-the wedges (B) by lateral sliding.
Disconnect the brake wear sensor.
Unscrew the rigid sewerage-connection
from the brake flexible hose.
Remove the safety washer of the flexible
connection from the stopper and dis mount the
caliper.
Check:
- the state of flexible connection;
- the state of brake disk;
- the state of brake pads;
- the state of protection bellow.
Replace the damaged or worn parts.
Fill the caliper with brake fluid.
Mount on the caliper:
- aerating screw;
- the flexible connection with a new
copper gasket.
Push the piston by means of the FR 500
device.
Unscrew the flexible connection from caliper and the purging screw.
R
EMOUNTING
vnx.su