Repair Manual

FRONT BEARING ELEMENTS
31 - 20
31
BRAKE C ALIPER SUPPORT
D
ISMOUNTING
Lift the vehicle on a two columns
elevator;
Dismount:
- the wheel;
- the caliper without disconnecting the
flexible connection;
- the brake pads.
Dismount:
- the two screws M 6 x 1 that attach
the protector on the brake caliper support;
- the two screws M 8 x 1,25 that
attach the brake caliper support on the steer-
ing knuckle;
- the two screws M 12 x 1,25 that at-
tach the brake caliper support on the steering
knucklethe brake caliper support.
R
EMOUNTING
NOTE:
Upon remounting, grease the screws with FIXAMED R 58 and replace the Grower
washers.
Place the brake caliper support in the right position.
Tighten the screws M 12 x 1,25 at the required moment of 6,5 daNm.
Tighten the screws M 6 x 1 that attach the protector at the required moment of 1,3 daNm.
Mount:
- the brake pads;
- the brake caliper support;
- the wheel.
Take down the vehicle from the elevator.
TIGHTENING MOMENTS ( în daNm )
The attachment caliper support screw on steering knuckle .......6,5
The attachment protector screw on the caliper support.................1,3
The attachment protector screw on the steering knuckle............
.......2
vnx.su