Repair Manual

FRONT BEARING ELEMENTS

31 - 27

RONT SUSPENSION TIGHTENING MOMENTS

- Upper arm shaft nut...............................................................9,5 daN.m

- Lower arm shaft nut................................................................11 daN.m

- Upper ball joint nut...................................................................5 daN.m

- Lower ball joint nut...................................................................5 daN.m

- Steering ball joint nut................................................................4 daN.m

- Stabilizer rod shaft nut..............................................................8 daN.m

- Steering connecting rod lower nut.........................................1,5 daN.m

- Shock absorber lock nut.........................................................1,5 daN.m

- Front shock absorber lock nut...................................................6 daN.m

- Stabilizer rod shaft attachment nut.........................................1,5 daN.m

IMPORTANT!

Since the shock absorbers are stored in the spare parts warehouses in horizontal

position ,it is possible, that they get depressed.

That is why ,before mounting on the motor car, the shock absorbers shall be pressed

by shifting the rod upwards and downwards (the shock absorber in vertical position).

SUSPENSION - TIGHTENING MOMENTS

STABILIZER ROD

VEHICLE TYPE DIAMETER ( mm )

Pick - up 1304, 1305,1307 19

NOTE: Make sure the suspension springs of each axle have the same characteris-

tics.

TYPE COIL DIAMETER FREE LENGHT /

OF MOTOR CARE ( mm ) UNDER LOAD daN/mm

RONT SPRINGS

Pick - up 1304, 1305,1307 14,5 410 / 250

vnx.su