Repair Manual

31
FRONT BEARING ELEMENTS
31 - 29
R
EMOUNTING
Grease the threaded parts of the shock absorber with special MoS2 grease.
Press the rod , tilt and place the shock absorber.
Fully screw the shock absorber into the lower joint.
Pull the shock absorber rod by means of the SUS 513 device.
Position the rubber buffers and the crossbar.
Tighten the upper nut at the required moment.
Tighten the lock nut.
Tighten at the required couple:
- the lower lock nut;
- the stabilizer rod shaft nut.
Dismount the SUS 478 – 01 device.
Mount the wheel.
Lower the vehicle from the elevator.
Remove the PF 509 support crossbar.
FRONT SHOCK ABSORBER
vnx.su