Repair Manual

31
FRONT BEARING ELEMENTS
31 - 33
FRONT STABILIZER ROD
D
ISMOUNTING
Unscrew :
- the attachment nuts (1)and (2) of the
casing on the longitudinal girder;
- the nuts (3) of the stabilizer rod aux-
iliary connecting rod.
Dismount the stabilizer rod together with
the auxiliary connecting rod.
Check the state of the elastic bushings; if
it shows marks of wear, replace the
auxiliary connecting rod.
R
EMOUNTING
Mount the auxiliary connecting rods on the stabilizer rod.
Grease the auxiliary connecting rod shaft with special MoS2 grease.
Mount the assembled stabilizer rod.
Press the front axle at a distance D = 45 mm by means of the TAV 238 – 02 device.
Tighten at the required moment:
- casing attachment nut;
- auxiliary connecting rods shaft nuts;
- the nuts that attach the auxiliary connecting rod to the stabilizer rod.
vnx.su