Repair Manual

33
REAR BEARING ELEMENTS
33 - 9
BRAKE SHOES
R
EMOUNTING
The shoes assembled with the lower return spring is attached on the plate ( the shoes P
foots in contact with supporting plate C).
Remount the auxiliary connecting rod assembled with the hand brake lever.
By means of a brake shoes nipper, set the upper connection of shoes by means of the
upper return spring.
Mount the brake shoes maintaining clips.
Apply a sealant layer ( ROMTIX 1502 ) in the areas of the maintain clips with the
brake plate.
Assembly the brake plate with the drum – hub assembly.
Tighten at the required moment the attachment screw of the assembly “drum - rear axle
brake plate”.
Drum clearance adjustment:
- rotate downward the eccentric until the drum is locked than rotate it upward with
1/12 rotations ( aprox. 30’).
- after performing drum adjustment, it must be easy rotating by hand.
- begin with the compression shoe.
vnx.su