Repair Manual

VALUES AND SETTINGS
07
07 - 16
CONTROL VALUE OF REAR AXLE ANGLES
* In order to check and adjust the front axle angles values, respectively the rear axle ones, the
following must be done:
- perform the tires checking concerning:
- dimensions
- inflating pressure
- degree of wear
- perform the joints checking:
- elastic joints condition
- ball joint clearance
- wheel bearing clearance
The vehicle must be obligatory:
- positioned with the wheels on bench rotating plates being in horizontal direction
- braked ensured
- suspension tested, for vehicle setting at its free height
- steering brought at central point and steering rack blocked in this position.
These operations are to be followed by optical device attachment on vehicle, observing the
prescriptions of the steering measurement bench manufacturer.
COMMERCIAL U 75 / 4 X 4 DRIVE (1304, 1307)
Not adjustable
Not adjustable
Empty
Empty
Empty
0
0
± 19'59''
(For two wheels)
Toe out
0
0
± 19'59''
ANGLES
CAMBER
PARALLELISM
ELASTIC JOINTS BLOCKING
VALUES
VEHICLE
POSITION
ADJUSTMENTS
vnx.su