Repair Manual

35
WHEELS AND TYRES
RIMS
The wheels identification marking is represented in two ways:
- engraved marking for steel rims;
- cast marking for aluminum rims.
The marking enables acknowledgment of the main wheels dimensions criteria.
This marking may be:
- complete.
Example: 5 J 14 3 CH 48, or
- simplified.
Example: 5 J 14
A B C D E F
Wheels Width The rim φ Nominal Number of Tire Offset
type (in inches) edge profile (in inches) fixing points staffing ( in mm )
Under tire bead profile
5 J14 5 J 14 3 CH 48
3CH48
5 J14 5 J 14 5 CH 48
5CH48
The wheel bolts (studs) are situated on a diameter of 100 mm.
Maximum axial runout: 1,2 mm measured on the rim edge ( in G ).
Maximum radial runout: 1,2 mm measured on the bedding side of the tires beads.
35 - 1
CHARACTERISTICS
vnx.su