Repair Manual

STEERING ASSEMBLY
36
Dismount:
- the attachment screws of the elastic coupling;
- the steering box attachment screws on the cross rod.
NOTE:
If the steering gear box is not replaced, do not dismount the eccentrics safety rings,
so that, after remounting, it will not be necessary to adjust the height of the steering
gear box.
R
EMOUNTING
Perform the dismounting operations in the reverse order:
Grease the ball joints with Li Ca Pb Hp2
grease.
Check the state and the attachment of the
protection bellows of the steering box.
Tighten the steering gear auxiliary
connecting rods shafts nuts to the required
moment.
Tighten the elastic coupling nuts to the
required moment.
Check and adjust:
- the steering gear box height, after
which, the screws by means of which the box
is attached to the cross rod are tightened at
the required moment;
- the parallelism.
36 - 4
SETTING THE STEERING GEAR CENTRAL POINT
vnx.su