Repair Manual

STEERING ASSEMBLY
36
REMOUNTING
Carefully clean the rack and the noise absorber bearing seat and grease with a special
grease containing MoS2.
Mount the elastic rings on the noise absorber bearing.
Rotate the steering wheel towards the left until the rack is on the extreme right position.
Mount the following parts on the rack:
- the new noise absorber bearing;
- the support washer;
- the old noise absorber support.
Tem porarily tighten the joint body of the steering auxiliary connecting rod.
Rotate the steering wheel until the rack is completely withdrawn; in this way, the new
noise absorber bearing gets into its seat.
Dismount:
- the articulation body ;
- the worn noise absorber bearing.
Check if the noise absorber bearing got into its seat and if the outer washer does not
cover the safety ring.
Dismount:
- the safety ring;
- the steering auxiliary connecting rod;
- the protection bellows.
Check and adjust the parallelism.
NOISE ABSORBER BEARING
36 - 6
vnx.su