Repair Manual

MECHANICAL ELEMENTS CONTROLS

REMOUNTING

Re mounting is done by performing in the reverse order, the dismounting operations.

Before mounting grease the parts with grease UM 170LiCa Pb

2M.

Tighten at the required moment the attachment nuts and screws:

- nuts M8 ..........................1,5 - 2 daNm

- screws M7 .......................... 1 - 1,5 daNm

GEARS CONTROL ADJUSTMENT

Engage the end lever of the gearbox in the

velocity step IV.

Place in contact the plug of the control

lever with an adjustm ent washer of 13 +/- 0,5 mm,

placed between the control box wall and the

plug, observing also the value W = 56 +/-1.

Tighten at the required moment the strap

attachment screws (1,8 –1,9 daNm) and the

elastic joints at the control shaft end

(1,1 – 1,9 daNm) observing the value L=10.

The strap must be in horizontal position

with the screws heads down.

Attach the return spring.

NOTE:

Before mounting grease the joints with

grease LiMoS2

GEARBOX CONTROL MECHANISM

37 - 20

13 +/- 0,5

vnx.su