Repair Manual

HEATING

61 - 1

ISMOUNTING

Disconnect the battery.

Dismount the ash try from the dash board.

Dismount the attachment screws (4) of the block on the dash board and detach the

block from its place.

Disconnect:

- the control cables (5) of the flaps;

- the control cable (6) of the climate control valve.

EMOUNTING

Perform the dismounting operation in the reverse order, observing the following

conditions:

-when remounting the flaps cables, operate one by one other, the levers (1) and (2)

to the left, leaving a clearance of 3 – 4 mm, the cable sheath being attached in this

position, by means of a clip and check the correct operation of the lever and the flap

closing;

- the control cable (6) of the climate control valve (7) is mounted to the lever (3), so

that the valve is set in the open position ( the arrow direction ) and the lever (3) is moved

towards right, leaving a clearance of 3 – 4 mm. In this position attach the cable sheath by

means of clip, than check the correct operation of the lever in the position corresponding

to the valve closing, respectively opening.

CLIMATE CONTROL BLOCK

13 2

vnx.su