Repair Manual

10
10 - 13
ENGINE AND LOWER ENGINE UNITS
Remove the jack from under the gearbox.
Mount the lifting device.
Move the engine-gearbox assembly
forward,bend it and lift it.
Place the engine on support.
Dismount the gearbox ( if necessary).
R
EMOUNTING
Perform in the reverse order the operations descibed at the dismounting.
PA RTICULARS UPON REMOUNTING
Slightly grease w ith grease Li Ca Pb type II the grooves of the front axles pinions.
Upon mounting the elastic pins,the notches shall be oriented towards the exterior (wheel).After
mounting ,a ball of sealer shall be placed at the ends of the pins,for sealing.
Adjust the clutch stroke: 2,5 – 3 mm.
Perform :
- oil fill up of the gearbox and the engine;
- filling and aeration of the cooling system.
Adjust the engine running (ignition and carburation).
Adjust the speeds command (see chapter 37 “ Speeds command ”).
Tighten the fixing nuts and screws according to the moments mentioned in the bellow table:
FIXING TIGHTENING
MOMENTS ( daNm )
Gearbox control connecting rod 4
Steering connecting rod 3
Upper shaft ball joint 5
Gearbox filling and draining plug 2,50
Downlead tube clip for exhaust pipe 1,70
Engine support on block 1,70
Buffer on support 1,70
Gearbox cross bar on gearbox 1,20
Cross bar on lateral buffers 1,70
ENGINE AND GEARBOX DISMOUNTING - REMOUNTING
vnx.su