Repair Manual

AIR CONDITIONING
62
62 - 9
COMPRESSOR
R
EMOUNTING
Position the compressor on the attachment supports.
Tighten the compressor on the supports, by means of 3 screws, which are to be initial screwed
in the following order : front upper left, rear lower right, front lower left.
Position and tighten the tie rod on the compressor upper support and on the cylinders hous-
ing.
Screw and tighten at the required moment the compressor attachment screws in the following
order : front upper left, front lower left, rear upper right, rear lower right
(3,5 daNm).
Tighten at the required moment the tie rod attachment screw on the cylinder housing (3,5
daNm).
Mount and tension the alternator belt by acting upon the tightener screw (see chapt.
” Belts tightening checking and tensioning “), then lock it, by tightening the tightener nut at the
required moment (3,5 daNm).
Tension the alternator belt (see chapt.”Belts tightening checking and tensioning “) and tighten
at the required moment (1,25 daNm) the alternator clamp attachment nut. and the clamp for
alternator belt tightener.
Tighten at the required moment the alternator attachment screw on the support
(2,4 daNm).
Mount the pipes to the compressor and tighten them at the required moment (2,5 daNm).
ATT EN TION !
The compressor – evaporator pipe of ˚”, is the suction pipe, and the compressor –
condenser pipe of 13/32 ”, is the discharging pipe ( in case mounting is not correct, the
system is not working).
Fill the refrigerant circuit and check the climate control system operation.
NOTE : When compressor is replaced, obligatory replace also the tank filter.
vnx.su