Repair Manual

85
WINDSCREEN WIPERS
85 - 5
R
EMOUNTING
Clean the parts.
Check the state of the parts ( pinions, bearings, collector ), replace the defective or worn parts.
Grease the parts with grease type LiCaPb type II.
Mount: the rotor, the bearing at the back of the motor, the reduction gear casing, the pinion,
and the reduction gear cap.
Adjust the axial clearance of the rotor (C); the screw should gently press the rotor shaft end.
Mount the windscreen wiper drive motor on the mechanism support.
WINDSCREEN WIPER DRIVE MOTOR COAL BRUSHES REPLACEMENT
The operation shall be performed after dismounting the mechanism off the vehicle.
D
ISMO UNTING
Dismount the drive motor from the
windscreen wiper mechanism.
Dismount : the reduction gear and the rotor.
Disconnect the coal brushes terminals (A, B
, E).
Dismount the coal brushes.
R
EMOUNTING
Check the state of the collector and its chan-
nels.
Mount the new coal brushes; check the free
displacement of the coal brushes in the supports.
Mount the rotor and the reduction gear.
Adjust the axial clearance of the rotor, by
means of the adjustment screw.
Mount the drive motor on the mechanism.
- loosen the adjustment screw of the rotor axial clearance.
Dismount: the reduction gear cap, the pinion.
2. Rotor dismounting:
- unscrew the attachment screws (A) of the reduction gear casing, on the drive engine.
Dismount: the reduction gear casing, the bearing at the back of the motor and the rotor.
WINDSCREEN WIPER DRIVE MOTOR
vnx.su