Repair Manual

10
10 - 26
ENGINE AND LOWER ENGINE UNITS
Dismount the engine flywheel.
Check the marking of the connecting rods:
number 1 towards the flywheel ond on the reverse
side of the camshaft.
Dismount the connecting rods caps and the
half bushings and place them in order.
The bearing caps are marked from 1 to 5
number 1 towards the flywheel.
Dismount the bearing caps and the half bush-
ings and place them in order.
Dismount the crankshaft.
Dismount the half bushings from the
connecting rod and from the block and place them
in order.
Remove the axial clearance adjustment thrust
washers.
Take out the bearing annular oil seal.
Rotate t he engine by 180°, dismount the MOT 484 device a nd take out :
- the engine shield;
- the gaskets at the bottom of the jackets.
Dismount the block from the support.
DISMOUNTING - MOUNTING
vnx.su