Repair Manual

10
10 - 33
ENGINE AND LOWER ENGINE UNITS
Compress the springs by means of the MOT 382 compression device and mount the lock
half cotters.
Mount the cylinder head closing plate and the water pump with new gaskets.
Mount the alternator support.
Mount the cylinder head with new gasket observing the mounting instructions.
Mount the tilter shafts in the place where they have been removed from.
Adjust the tilters.
Mount the tilters c ap.
Adjust the acceleration pedal stroke.
Fill and aerate the cooling system.
Check and adjust the engine(ignition,carburation).
Retightem the cylinder head after 800 km of driving.
VA LV E SPRING REPLACEENT
( on car )
Disconnect the battery.
Disconnect the acceleration cable.
Dismount the tilters cap.
Dismount the spark plug.
Mount the MOT 61 device for valve
maintaining in the place of the spark plug.
Dismount the tilter shaft.
Compress the s pring by means of the
MOT 382 compressing device and take out the
lock half cotters.
Take out the upper tray and the spring.
Clean the seat of the lower tray.
Place back in the previous site:
- new spring ( with the close coils
towards the cylinder head,the end marked with
green paint);
- the upper tray.
DISMOUNTING – MOUNTING
vnx.su