Repair Manual

10
10 - 34
ENGINE AND LOWER ENGINE UNITS
Compress the spring by means of the MOT 382 device and mount t he lock half cotters.
Mount the tilter shaft.
Adjust the tilter.
Mount the tilters c ap.
The nuts tightening moment: 0,5 – 0,7 daNm.
Mount the acceleration cable and adjust the acceleration pedal stroke.
Dismount the MOT 61 valve support device and mount the spark plug.
Check and adjust the engine ( ignition,carburation).
REPLACEMT OF THE VALVE SHAFT SEALING RING
Disconnect the battery.
Dismount the acceleration cable.
Dismount the tilters cap.
Dismount the spark plug.
Mount the MOT 61 valve supprt device in
the place of the spark plug.
Dismount the tilter’s shaft.
Compress the spring by means of the MOT
382 compression device and take out the lock
half cotters.
Remove:
- the upper tray;
- the spring.
Clean the seat of the lower tray.
Dismount the sealing ring of the valve shaft using
the MOT 1335 device.
Mount the new sealing ring using the
MOT 250 device.
Re place at the previous place:
- the spring ( with the close coils towards
the cylinder head);
- the upper tray.
DISMOUNTING - MOUNTING
vnx.su