Repair Manual

10
10 - 46
ENGINE AND LOWER ENGINE UNITS
OIL PLATFORM PLUGS REPLACEMENT
D
ISMO UNTING
Dismount the plugs from the block by boring with a φ 10 drill.
Wash the block,clean the platform and the channels in the block and blow it with compressed
air.
R
EM
OUNTING
Oil the new plugs with OMNI - FIT
RAPID.
Place the plugs (1) in their seats in the block
and clamp them by means of the
MOT 111A rivet set.
REPLACEMENT OF THE CRANKSHAFT BEARING ANNULAR OIL SEAL
D
ISMO UNTING
Disconnect the battery.
Dismount:gearbox,clutch mechanism and
the disk,flywheel and the worn annular oil seal.
R
EMOUNTING
Place the new annular oil seal on the
MOT 259 - 01 mounting device.
Lubricate with oil the exterior diameter of the
annular oil seal.
ATTENTION:
The edge of the annular oil seal is very
fragile:take protection steps upon mount-
ing.
DISMOUNTING - MOUNTING
vnx.su